主页 电源管理 交流/直流和直流/直流控制器（外部 FET）
主页
电源管理
交流/直流和直流/直流控制器（外部 FET）
新

LM517701

正在供货

78V wide-VIN bidirectional 4-switch buck-boost controller

立即订购
数据表

LM517701

正在供货
数据表 立即订购

产品详情

Rating Catalog Topology Buck-Boost Vin (max) (V) 78 Vin (min) (V) 2.8 Vout (max) (V) 60 Vout (min) (V) 3.3 Features Adjustable current limit, Dynamic voltage scaling, Enable, Frequency synchronization, Light-load efficiency, Load Disconnect, Power good, Spread Spectrum, Synchronous rectification, Tracking, UVLO adjustable Operating temperature range (°C) -40 to 125 Iq (typ) (µA) 60 Duty cycle (max) (%) 100 EMI features Frequency Dithering, Spread Spectrum
Rating Catalog Topology Buck-Boost Vin (max) (V) 78 Vin (min) (V) 2.8 Vout (max) (V) 60 Vout (min) (V) 3.3 Features Adjustable current limit, Dynamic voltage scaling, Enable, Frequency synchronization, Light-load efficiency, Load Disconnect, Power good, Spread Spectrum, Synchronous rectification, Tracking, UVLO adjustable Operating temperature range (°C) -40 to 125 Iq (typ) (µA) 60 Duty cycle (max) (%) 100 EMI features Frequency Dithering, Spread Spectrum
HTSSOP (DCP) 38 62.08 mm² 9.7 x 6.4
  • Wide input range from 3.5V to 78V (85V absolute maximum)
    • Minimum 2.8V when V(BIAS) > 3.5V
  • Output voltage from 3.3V to 78V
  • Low shutdown IQ of 3µA
  • Low operating IQ of 60µA
  • 3% reverse current limit accuracy for precise charging currents
  • Average input and output current monitor or limiter
  • Dynamic output voltage tracking for PWM or analog input signals
  • Power save mode (PSM) selectable for high light load efficiency
  • Two integrated high-voltage supply LDOs with automatic selection
  • Fixed frequency across all operating modes (boost, buck-boost, buck)
    • Forced PWM mode selectable
    • Switching up to 1.8MHz for small solution and component size
    • External clock synchronization
  • Spread spectrum operation selectable
  • Adjustable undervoltage protection
  • Hiccup overcurrent and short protection
  • Wide input range from 3.5V to 78V (85V absolute maximum)
    • Minimum 2.8V when V(BIAS) > 3.5V
  • Output voltage from 3.3V to 78V
  • Low shutdown IQ of 3µA
  • Low operating IQ of 60µA
  • 3% reverse current limit accuracy for precise charging currents
  • Average input and output current monitor or limiter
  • Dynamic output voltage tracking for PWM or analog input signals
  • Power save mode (PSM) selectable for high light load efficiency
  • Two integrated high-voltage supply LDOs with automatic selection
  • Fixed frequency across all operating modes (boost, buck-boost, buck)
    • Forced PWM mode selectable
    • Switching up to 1.8MHz for small solution and component size
    • External clock synchronization
  • Spread spectrum operation selectable
  • Adjustable undervoltage protection
  • Hiccup overcurrent and short protection

The LM51770x is a four switch buck-boost controller. The device provides a regulated output voltage if the input voltage is higher, equal, or lower than the adjusted output voltage. In power save mode, the device supports high efficiency with low output loads due to its low quiescence currents. In power save mode, the device supports high efficiency close to 99% efficiency over the full range of the output current. The LM51770x runs at a fixed switching frequency, which is set through the RT or SYNC pin. The switching frequency remains the same during buck, boost, and buck-boost operation. The integrated and optional average current monitor helps monitor and limit input and output current of the LM51770x. This feature also supports charging backup power elements, like batteries or capacitors, with constant current (CC) and constant voltage (CV).

The LM51770x is a four switch buck-boost controller. The device provides a regulated output voltage if the input voltage is higher, equal, or lower than the adjusted output voltage. In power save mode, the device supports high efficiency with low output loads due to its low quiescence currents. In power save mode, the device supports high efficiency close to 99% efficiency over the full range of the output current. The LM51770x runs at a fixed switching frequency, which is set through the RT or SYNC pin. The switching frequency remains the same during buck, boost, and buck-boost operation. The integrated and optional average current monitor helps monitor and limit input and output current of the LM51770x. This feature also supports charging backup power elements, like batteries or capacitors, with constant current (CC) and constant voltage (CV).
filter 查找其他 交流/直流和直流/直流控制器（外部 FET）
下载 观看带字幕的视频 视频

技术文档

star =有关此产品的 TI 精选热门文档
未找到结果。请清除搜索并重试。
查看全部 1
类型 标题 下载最新的英语版本 日期
* 数据表 LM51770x 78V Wide VIN Bidirectional 4-Switch Buck-Boost Controller 数据表 (Rev. A) PDF | HTML 2025年 8月 20日

设计和开发

如需其他信息或资源，请点击以下任一标题进入详情页面查看（如有）。

评估板

LM5177EVM-HP — LM5177 四开关降压/升压控制器评估模块

LM5177EVM-HP 展示了一款采用 LM5177 宽输入电压降压/升压控制器的高功率灵活降压/升压设计。该评估模块经配置，可在 4.2V 至 36V 的输入电压范围内运行，并提供 16V 稳压输出，负载电流高达 9.4A。
用户指南: PDF | HTML
英语版 (Rev.D): PDF | HTML
TI.com 上无现货
计算工具

LM51770-QUICKSTART-CALC — LM51770 BuckBoost Quickstart Calculator Tool

LM51770 BuckBoost Quickstart Calculator Tool. This standalone tool facilitates and assists the power supply engineer with the design of a DC/DC buck-boost converter based on the LM51770.
支持的产品和硬件

支持的产品和硬件

产品
交流/直流和直流/直流控制器（外部 FET）
LM51770 — 78V 宽 VIN 双向 4 开关降压/升压控制器 LM517701 — 78V wide-VIN bidirectional 4-switch buck-boost controller
硬件开发
评估板
LM51770EVM-HV — LM51770 buck-boost controller evaluation module
下载
封装 引脚 CAD 符号、封装和 3D 模型
HTSSOP (DCP) 38 Ultra Librarian
应遵守 TI 评估类商品的标准条款与条件。

订购和质量

包含信息：
  • RoHS
  • REACH
  • 器件标识
  • 引脚镀层/焊球材料
  • MSL 等级/回流焊峰值温度
  • MTBF/时基故障估算
  • 材料成分
  • 鉴定摘要
  • 持续可靠性监测
包含信息：
  • 制造厂地点
  • 封装厂地点

推荐产品可能包含与 TI 此产品相关的参数、评估模块或参考设计。

支持和培训

视频