Seleccione una versión

Seleccione una versión

No se encontraron resultados. Borre su búsqueda y vuelva a intentarlo.

BQ28Z620-DEVICE-FW

Firmware for BQ28Z620 family of gauges

Seleccione una versión
No se encontraron resultados. Borre su búsqueda y vuelva a intentarlo.
Última versión
Versión: R1-V1.01
Fecha de publicación: 9/08/2023
open-in-new

Notas de la versión

open-in-new

Ver detalles del software

lock

bq28z620R1FirmwareBundle-1.01-windows-installer.exe.zip  — 4410 K

BQ28Z620-R1 v1.01 firmware installer

Suma de comprobación SHA-256
lock = Requiere aprobación de exportación (1 minuto)
Productos
Medidores de carga de baterías
BQ28Z620 — Indicador de combustible de batería con protector integrado para paquetes de las series 1 a 2 con 1.
Desarrollo de hardware
Placa de evaluación
BQ28Z620EVM-071 — Módulo de evaluación BQ28Z620 para indicador de combustible de batería de iones de litio de celda de

Información de la versión

The Texas Instruments BQ28Z620 device is a highly integrated, accurate, 1-series to 2-series cell gas gauge and protection solution, enabling autonomous charger control and cell balancing.

The BQ28Z620-DEVICE-FW enables autonomous charge control through Master Mode I2C broadcasts of charging current and voltage information, eliminating software overhead that is typically incurred by the system’s host controller.

The BQ28Z620-DEVICE-FW device provides a fully integrated pack-based solution with a flash programmable custom reduced instruction-set CPU (RISC), safety protection, and authentication for 1- to 2-series cell Li-ion and Li-polymer battery packs.

The BQ28Z620-DEVICE-FW communicates via an I2C compatible interface and combines an ultra-low-power, high-speed TI BQBMP processor, high-accuracy analog measurement capabilities, integrated flash memory, an array of peripheral and communication ports, an N-CH FET drive, and a SHA-1 Authentication transform responder into a complete, high-performance battery management solution.

Features

  • Autonomous battery charging control, using a dedicated MASTER mode I2C interface
  • 400-kHz I2C bus communications interface, including a 1.2-V logic level for high-speed programming and data access
  • Cell balancing with an internal bypass to optimize battery health
  • A high-side protection N-CH FET drive enables serial bus communication during fault conditions
  • Programmable protection levels for voltage, current, and temperature
  • Support for simultaneous current and voltage sampling
  • Supports down to 0.5-mΩ current sense resistor while capable of 1-mA current measurement
  • SHA-1 authentication responder for increased battery pack security